Fujitsu DL3100 User Manual page 170

FUJITSU DL3100
init=FEH;
The printer condition is initialized to the user default
setting.
The parm bytes overwrite the user default setting.
The values used for initialization are saved in NV
RAM.
The download font is cleared.
init=FFH;
The printer Condition is initialized to the factory
default setting.
The values used for initialization are saved in NV
RAM.
The download font is cleared.
Id; This parameter specifies the parm conditions
id=03H, 16H, 23H, 24H
parm1 and parm2 are valid.
If the following parm are specified, these parm are
ignored.
See the following parm 1 and 2 tables.
parm1
bit
7 : Discard byte
6 : Reserved
5 : Alarm
4 : Auto CR
3 : Auto LF
2 : Form Length
1 : Slashed Zero
0 : Character Set
C-30
Function
followed by this id.
The supported values of id are 03H, 16H, 23H,
24H, B1H and B4H.
If the id is any other value, the parm bytes are
ignored. V03
ON
Ignore this byte
Enable
Auto CR after LF
Auto LF after CR
12 inches
Zero Slashed
Set 2
OFF
Process this byte
Disable
No CR after LF V03
No LF after CR V03
11 inches
Zero not slashed
Set 1
Command
User's Manual