Fujitsu DL3100 User Manual page 180

FUJITSU DL3100
Set bottom margin
This command specifies the number of lines to be
skipped at the bottom of each page, which creates a
bottom margin.
Cancel bottom margin
Set horizontal margins
This command sets the left and right margins,n1 and
n2 specify the number of the colums.
• Use n1 to select the left margin position.
• Use n2 to select the right margin position.
Control-code character printing
Print Characters from a Code Page
• This command enables you to print characters from
the All Character Code table.
• n1 and n2 specify the number of characters to be
printed.
• The number of characters printed is 256*n2+n1.
• Control codes included in the character data are not
executed.
Print one character
• This command enables you to print a single
character from the All Character Code table.
• A control code is not executed if the code is sent
immediately following this instruction.
C-40
Function Command
ESC N (n)
ESC O
ESC X n1 n2
ESC \ n1 n2
ESC ^
User's Manual