Fujitsu DL3100 User Manual page 149

FUJITSU DL3100
Define user-defined characters
Sets the parameters for user-defined characters and then
sends the data for those characters,as described below:
n = Character code of the first character to be
user-defined
m = Character code of the last character to be
user-defined
a0 = Space to the left of each proportional user-defined
character
a1 = Actual width of user-defined characters
a2 = Space to the right of each proportional user-defined
character
d1 . . . dk = Character data
(0 ≤ n ≤ 127,0 ≤ m ≤n)
LQ mode
0 ≤ a1 ≤ 37
0 ≤ a0 + a1 + a2 ≤ 42
Normal characters
k = 3Xa1
Notes
• The following maximum character widths are
recommended. (heightXwidth)
Print quality
Draft Normal
size
Draft Super/
subscript
LQ Normal
size
LQ Super/
subscript
• Send the ESC % 1 command to switch to user-defined
characters.
• Set n=m when only 1 character is defined.
User's Manual
Function
Draft mode
0 ≤ a1 ≤ 15
0 ≤ a0 +a1 + a2 ≤ 18
Super/subscript characters
k = 2Xa1
10cpi 12cpi 15cpi
24x12 24x10 24x 8
16x12 16x10 16x 8
24x36 24x30 24x24
16x36 16x30 16x24
Command
ESC & NUL
(n) (m) (a0 a1
a2.d1.d2 .. . .
dk)
Proportional
Not Available
Not Available
24x42
16x42
C-9