Fujitsu DL3100 User Manual page 159

FUJITSU DL3100
Counter specifies the number of times to repeat the next
byte of data
according to the formula below.
256 – (counter byte) + 1 = (number of times to repeat
next byte)
(counter byte) = 257 – (number of times to repeat next
byte)
(c = 0 ,1,v = 5,10, 20,h = 5,10, 20,m = 1, 8, 24)
(0 ≤ nL ≤ 255,0 ≤ nH ≤ 127,0 ≤ d ≤ 255)
The following vertical and horizontal printing resolution
combinations are available:
v
20
20
10
Stylus COLOR only
5
Notes
• Use only one image density and do not change this
setting once in raster graphics mode.
• When MicroWeave is selected, the image height m
must be set to 1.
• Special coated stock paper available from EPSON is
required when printing raster graphics at 720 dpi.
• This command can be used only during graphics
mode, entered by sending the ESC ( G command.
• The final print position is the dot after the far right dot
on the top row of the graphics printed with this
command.
• Print data that exceeds the right margin is ignored.
• Do not specify the vertical movement in increments
smaller than the current print density.
User's Manual
Function
h v(dpi)
20 180
20 180
10 360
5 720 720
h(dpi) m
180 1,8 or 24
360 1,8 or 24
360 1,8 or 24
1(with special paper)
Command
C-19