Fujitsu DL3100 User Manual page 156

FUJITSU DL3100
Setting the page format
Set page length in defined unit
(page length) = ((mH × 256) + mL) × (defined unit)
(nL = 2, nH = 0,0 < ((mH × 256) + mL) × (defined unit)
≤ 22)
Set page format
Sets the top and bottom margins in the defined units(set
with the ESC ( U command) according to the following
formulas:
(top margin) = ((tH × 256) + tL) × (defined unit)
(bottom margin) = ((bH × 256) + bL) × (defined unit)
(nL = 4, nH = 0, top margin < bottom margin, bottom
margin < 22 inches)
((tH × 256) + tL) < ((bH × 256) + bL)
((bH × 256) + bL) × (defined unit) ≤ 22
Default
Continuous paper: None
Single-sheet paper: (top margin) = top-of-form position
Notes
• Measure both top and bottom margins from
the top edge of the page.
• Send this command before paper is loaded, or when
paper is at the top-of-form position.
Otherwise, the current print position becomes the
top-margin position (this results in undesirable
contradictions between the actual and logical page
settings).
• Changing the defined unit does not affect the current
page-length setting.
Set page length in lines
Sets the page length to n lines in the current line spacing
(1 ≤ n ≤ 127, 0 < n × (current line spacing) ≤ 22 inches)
Set page length in inches
Sets the page length to n inches
(1 ≤ n ≤ 22)
C-16
Function
(bottom margin) = last printable line
Command
ESC ( C (nL)
(nH) (mL)
(mH)
ESC ( c (nL)
(nH) (tL) (tH)
(bL) (bH)
ESC C (n)
ESC C NUL
(n)
User's Manual