Advertisement
Section 1: Assembly & Set-up
Hydraulic Hook-up
Refer to Figure 1-20:
!
WARNING
To prevent serious injury or death:
•
Stop the tractor and release the pressure from the hydraulic
system before starting any work on the hydraulic system.
•
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. A doctor familiar with this
type of injury must treat the injury within a few hours or
gangrene may result. DO NOT DELAY.
h
IMPORTANT: The hydraulic system's hoses are
marked with the following information: maximum
pressure, manufacturer, production date, reference
code.
An example of how the information is indicated on the
hydraulic hoses is provided in Figure 1-20.
For more information on connecting the hydraulic hoses
to the tractor, see the hose connection decal applied to
the flail mower.
74979
Reference
A
Code of the hydraulic hose
B
Manufacturer's name
C
Hydraulic hose production date
D
Maximum operating pressure
Hydraulic Hose Information
Figure 1-20
24
OFM2660, OFM2672 & OFM2678 Offset Flail Mowers 333-142M
Table of Contents
Meanings
Blue Caps
1
Hydraulic Identification By Cap Colors
Figure 1-21
Refer to Figure 1-21:
The hoses are identified by different colored bands,
depending on their use.
1.
To connect correctly, refer to the colored caps
protecting the quick connect couplers:
•
Blue Caps (#1): Hoses for lateral adjustment.
•
Red Caps (#2): Hoses for incline adjustment.
2. Connect the quick release couplings with blue
caps (#1) to the duplex outlet on the tractor
designated for operating the lateral adjustment.
3. Connect the quick release couplings with red
caps (#2) to the duplex outlet on the tractor
designated for operating the incline adjustment.
h
IMPORTANT:
•
The lateral cylinder must always be set to not float.
•
The incline cylinder must be set to not float except
it may be set to float only while operating the
mower with the flail head on the ground.
4. Make sure that the hydraulic connections between
the mower and the tractor are set to not float and the
cylinders will not move while the control levers are
not being operated.
5. Continue with"Check Driveline Interference" on
page 25.
Red Caps
2
74972
3/1/21
Advertisement
