Page 2
Copyright 2006 All rights Reserved Land Pride provides this publication “as is” without warranty of any kind, either expressed or implied. While every precaution has been taken in the preparation of this manual, Land Pride assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein. Land Pride reserves the right to revise and improve its products as it sees fit.
Free-floating deck using three blades with center blade to the front. Four point chain suspension with counter balance springs. Includes 4 anti-scalp wheels to improve flotation in rolling and uneven terrain. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
8. X/M = Service per hours indicated in column or monthly (whichever comes first). X/A = Service per hours indicated in column or annually (whichever comes first). ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Hydrogen gas forms inside the battery. This gas is both toxic 24514 and flammable and may cause an explosion if exposed to a Wiring Harness Fusses flame. Figure 2-6 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
4. Remove the left side oil filter (#6) and properly a stalled engine. Refer to “Moving Mower with Stalled discard. Engine” on page 51 for more information. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Page 12
Right Side Left Side Right Side Left Side 23692 Hydraulic Oil Drain Plugs Location (Bottom View) Hydraulic Oil Filters and Oil Expansion Tank Location Figure 2-9 Figure 2-11 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Fuel Filter (Honda Engine Shown) Clean dirt from around fuel tank cap, remove cap and Figure 2-12 begin filling. Do not fill fuel tanks to the top if mowing on ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
General Engine Maintenance dirt. Detailed instructions and recommendations for break-in 8. Never operate a machine without an air filter installed. and regular maintenance are specified in the engine ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Always use genuine Land Pride filters. Failure to use original equipment replacement parts is an alteration and will not be considered for warranty in the event of a dust induced engine damage. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Ground drive belt Pump idler spring Deck drive pulley Pump tension idler Pump pulley Deck drive belt Pump idler arm 23976 Drive Belt Viewed from the Bottom Figure 2-18 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
4. Tighten blade bolt to 135 ft-lbs. of torque. Blade Sharpening HORIZONTAL CAUTION ALWAYS wear eye protection and gloves when sharpening a NAIL OR SHAFT blade. 19046 Blade Balancing Figure 2-20 ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Failure to correctly torque the bolt may result in the loss of the applied to the deck underside to minimize oxidation. blade which can cause serious injury. 3. Clean and touch up all scrapes with Land Pride spray paint. 4. Check blades and blade bolts for wear and replace if necessary.
8. Run machine at half speed for 5 minutes, checking operation of the control levers. Stop engine and check for oil leaks, loose fittings and so forth. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Quantity = As required 23930 Hours Right Blade Spindle Access through rubber slit in pulley cover. 1 Zerk Type of Lubrication: Multi-purpose Grease Quantity = As required 23933 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Gauge Wheel Bearing Zerk Located on hub of gauge wheel 2 Zerks (One on each gauge wheel) Type of Lubrication: Multi-purpose Grease Quantity = As required 23930 ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Wheel lug nuts arms. The pump linkage rods are properly adjusted when Blade bolts control levers are in neutral position and drive wheels are not turning. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Remove support blocking and safely lower effect the consistency to drive straight while pressing mower wheels to the floor. the control levers against the stops. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
12. Repeat steps 10 and 11 until correct gap is achieved. 23936 If correct gap cannot be achieved, see “Adjusting the Steering Dampener Adjustment Lever Arm” on page 33. Figure 3-4 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Figure 3-5 L-bolt Mounting Hole Measure gap between lever arm (#1) and hydraulic motor (#2). 24578 Park Brake Adjustment 24567 Figure 3-7 Park Brake Gap Figure 3-6 ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
(see Figure 3-15) Blocking up Deck is tight and deck is still resting on the 3" support Figure 3-13 blocks. Tighten jam nut “A” against the deck lift block. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
1” of space between the front nut and on the spring bar is used when the deck is placed in the transport and the rear nut on the deck lift block. Typical both mode. sides. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
3. Replace hairpin cotters (#1). NOTE: When the anti-scalp rollers are installed, the minimum cutting height is 1 1/2” with the anti-scalp rollers set at 3/4”. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
For your convenience the model numbers for the engines offered at this time have been listed below. NOTE: Remember all warranty on engines goes thru the OEM. Honda-GXV670V Kawasaki- FH721V 25hp/ FH680v 23hp ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
DO NOT ATTACH THE PULLER TO THE CLUTCH PULLEY as the flanges are very light and damage will occur. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
5. Connect the wiring and re-install deck belt tightening the over-center latch. 6. Re-install the guards. NOTE: Failure to install clutch guard will void the warranty of the clutch. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
10. Being careful not damage the output shaft on the bottom of the engine and the plastic shroud lift the engine straight up and remove from the frame. photo zt028 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
DO NOT OVER TIGHTEN THE HOSE CLAMP as this can collapse the intake and allow dirt into the engine. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
3. Hand tighten the nuts to the studs then evenly tighten the nuts alternating one to the other being careful not to warp the muffler flange. Nuts are to be torqued to 17 ft- lbs. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
3. Disconnect the wiring harness from the control panel and pull out thru the access port on the inside of the frame under the seat. 4. Repeat the steps above for the left hand tank. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
NOTE: You will use the fittings from the old pump with the new. 10. Remove the two bolts from the bottom of the pump and remove the pump photo zt010 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
7. Re-install ground belt. 8. Purge/prime the pump. See purge/prime sec. 5 Pg. 50 IMPORTANT: The pump must be primed before activation or terminal damage will occur! ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
7. Remove the hose adapters from the motor. You will use these on the new motor. photo zt015 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
See sec. 2 pg 29 4. Mount the wheel and tire. NOTE: If you drained the system you will need to prime the pump before activating the system. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
NOTE: To fill the filter you can do so by removing the clamp on the filter line and repeat the above process. photo zt002 5. Remove the clamp from the filter line. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
23643 bypass valves and two park brake release levers are Park Brake Release Lever (Right Side Shown) returned to their normal operating positions. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
2gpm. Repeat on the other side of the machine if necessary. NOTE: If the pump flow checks out contact Land Pride Service Dept. before going any futher. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
7. Remove the three bolts holding the solenoid to the mounting bracket the solenoid is now free. 8. Instructions are the same for either side. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
Land Pride Section 6: Brakes Brake Solenoid Installation 1. Reverse the above procedure. 2. The brake will have to be re-adjusted. See Brake Adjustments sec. 3 pg 32 ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
24733 8. Install the yoke place washer then the top cap and tighten the hex head bolt. ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...
6. With the deck in the down position pull the rod out slowly. This may require some force. 7. Now with the rod removed the steer arm supports can be removed. 8. To re-assemble reverse the previous steps. ® ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM 10/11/06...
Page 67
Land Pride Section 8: Frame & Steering Controls NOTES: ® 10/11/06 ZT60 and ZT72 Zero Turn Radius Mowers Riding Mowers Accu-Z 357-103SM...