Advertisement
Section 1: Assembly & Set-up
24513
Outer Shielding has been removed for clarity.
Driveline Maximum Length
Figure 1-25
Measure Driveline Maximum Length
Refer to Figure 1-25:
Driveline maximum length must, when fully extended,
have 1/3 overlap of the profile tubes with both inner and
outer profile tubes being of equal length as shown in
Figure 1-25. Check driveline maximum allowable length
as follows:
1.
Make sure "Check Driveline Collapsible Length"
on page 26 has been completed before continuing
with instructions below.
2. Apply multi-purpose grease to the inside of the outer
shaft.
3. Assemble the two driveline profiles together with just
1/3 overlapping of the profile tubes as shown.
4. Measure driveline "Maximum Allowable Length" and
record here ______.
5. Continue with "Driveline Hook-up" on page 22.
3/1/21
Table of Contents
OFM2660, OFM2672 & OFM2678 Offset Flail Mowers 333-142M
27
Advertisement
