(2) Enter a value (0 to 255) divided into four by periods in [IP Address] as the IP address of IPv4.
(3) Enter a value (8 to 30) in [Prefix Length] as the prefix length of IPv4.
(4) Select the IPv6 connection mode.
. OFF:
IPv6 is not used.
. MANUAL: Manual setting mode. IP Address and Prefix Length can be entered only in this mode.
. AUTO:
Auto acquisition mode. Values acquired are displayed in the IP Address and Prefix
Length columns respectively.
. DHCP:
DHCP server auto acquisition mode. Values acquired by the DHCP server are dis-
played in the IP Address and Prefix Length columns respectively.
When the "MANUAL" connection mode is selected, go to step (5).
When the "OFF", "AUTO" or "DHCP" connection mode is selected, go to step (7).
(5) Enter a value in [IP Address] as the IP address of IPv6.
(6) Enter a value (8 to 126) in [Prefix Length] as the prefix length of IPv6.
(7) Set the S1 (SYSTEM LAN1) or S2 (SYSTEM LAN2).
Click [Apply] after each setting, the setting is saved.
1-17-3. Network Settings for Connected Devices
Set the IP address when making PWS-100SC1/PWS-110SC1 (SCS) redundant or connecting the system
interface unit (SIU).
Procedure
1. Open the Maintenance Menu and click [Other Network] on the left side of the window.
The Other Network Setting window is displayed.
ICP-X7000
1-75 (E)