To make the panel horizontal
1. Remove the right and left module covers, cap (L), and
cap (R). (Refer to steps 1 and 2 in this section.)
2. Remove the four screws to detach the tab rack tool.
Tab rack tool
B3
6
View in the direction of arrow A
Tab rack tool
B3
6
1-20 (E)
A
Tab rack tool
B3
6
B3
3. Set the tab rack tool at the position shown in the figure,
and then install it with four screws.
Tab rack tool
B3
6
View in the direction of arrow A
B3
6
6
4. Install the extension adaptor. (Refer to steps 3 to 6 in
this section.)
5. Connect the AC adaptor and LAN cable, and clamp
them with two clampers, after installing the extension
adaptor. (Refer to step 6 of Section 1-4 )
Tab rack tool
B3
6
Tab rack tool
B3
ICP-X7000
A
6