Installing The Aux Panel - Sony ICP-X7000 Installation Manual

3. Lift the main panel with two or more persons, and then
place it on the adjustment console while supporting the
main panel with another person.
4. Secure the main panel to the adjustment console with
screws. (This figure shows 4-row type.)
B4 6
5. Install the right module cover, left module cover, cap
(L), and cap (R) by reversing steps 1 and 2.
6. Connect the AC adaptor and LAN cable, and clamp
them with two clampers, after installing the main
panel.
Bottom side of the panel
AC adaptor
1-18 (E)
Main panel
B4 6
clampers
LAN cable

1-5. Installing the AUX Panel

n
At least two persons are required to install the AUX panel
to the adjustment console.
Perform the following procedure to install the AUX panel.
Prepare the following screws and washers.
. Screw (B5 x 8): 4 screws
. M5 washer (Sony part number: 7-688-005-11): 4 washers
1. Detach the panel cover (L) and the panel cover (R) of
the AUX panel.
2. Lift the AUX panel with two or more persons, and then
place it on the adjustment console.
3. Secure the AUX panel to the adjustment console with
screws and washers.
4. Attach the panel cover (L) and the panel cover (R).
Panel cover (L)
B5 8
Washers
AUX panel
5. Connect the AC adaptor and LAN cable, and clamp
them with two clampers, after installing the AUX
panel. (Refer to step 6 of Section 1-4 )
Panel cover (R)
B5 8
Washers
ICP-X7000