Sony ICP-X7000 Installation Manual page 101

Installing operation module to the AUX panel
t
When two or more operation modules are installed to the
AUX panel, perform the same work as shown in "Installing
operation module to the main panel" to install and remove
adjacent operation modules.
Target modules
Refer to the target modules shown in "Installing operation
module to the main panel."
Installation
1. Detach the panel cover (L) and the panel cover (R) on
both sides of the operation module to be removed.
(Insert fingers into the hook areas on both sides and lift
the panel covers.)
2. Remove the operation module. (Refer to "Installing
operation module to the main panel.")
3. Install the operation module. (Refer to "Installing
operation module to the main panel.")
4. Attach the panel cover (L) and the panel cover (R).
Panel cover (L)
Operation module
Screws
(with stopper)
ICP-X7000
Installing operation module to the extension
adaptor (MKS-X7075)
Target modules
. MKS-X7026
. MKS-X7031TB Track Ball Module
. MKS-X7032
. MKS-X7033
. MKS-X7035
Installation
1. Remove the module covers on both sides of the opera-
tion module to be removed.
2. Loosen the four screws (with stopper) securing the
operation module.
3. Hold and remove the two front screws on both sides of
the operation module.
4. Disconnect the fine-wire coaxial cable from the con-
nector (CN1100) on the PIF-53 board, and remove the
operation module.
Panel cover (R)
Screws
(with stopper)
Extension adaptor
10-Key Pad Module
Key Fader Module
Utility/Shotbox Module
Key Control Module
Module cover
Module cover
Screws
(with stopper)
PIF-53 board
Operation module
Screws
(with stopper)
Fine-wire
coaxial cable
Cable Clamp
CN1100
2-5 (E)