Rack Mounting - Sony ICP-X7000 Installation Manual

Installation procedure
1. Connect the AC adaptor supplied with the menu panel,
the LAN cable (commercially available), and the
ground cable (commercially available).
2. Install the adaptor to the menu panel with the supplied
four screws (B3 x 5).
Adaptor
B3 5
Menu panel
3. Install the monitor arm (commercially available) to the
adaptor with the supplied four screws (B4 x 8).
n
Install the monitor arm according to the operation
manual of the monitor arm.
100 mm
75 mm
Adaptor
75 mm
100 mm
1-26 (E)
B3 5
AC adaptor
Ground wire
LAN cable
B4 8
B4 8
Monitor arm

1-11. Rack Mounting

The MKS-X2700/X7700 installs in a 19-inch standard
rack. To mount the MKS-X2700/X7700 in a rack, use the
specified rack mount kit and follow the procedure de-
scribed below.
Specified rack mount kit: RMM-10
n
If a rack mount kit other than the specified one is used, the
unit may not correctly install in a 19-inch standard rack.
Parts of the RMM-10
. Rack tools
. Right rack mount adaptor
. Left rack mount adaptor
. Rack tool attaching screws 6 pcs
. Adaptor attaching screws
1. Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolts or other fixings.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
c
When mounting the unit in the rack, note the following:
. Be sure to carry out this work with two or more persons.
. Be sure to mount in the rack with two persons or more.
. Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended
that a ventilation fan is installed to prevent temperature rise
inside the rack.
2 pcs
1 pc
1 pc
(B4 x 6: 7-682-560-09)
6 pcs
(B4 x 10: 7-682-562-09)
ICP-X7000