Example Of Connection Of Serial Tally Through A Network; Connection Example Of Network Aux Remote - Sony ICP-X7000 Installation Manual

1-15-5. Example of Connection of Serial Tally through a Network

Switcher Control Station
PWS-100SC1/PWS-110SC1
t
. Set system interface units (to be connected to external devices) in the tally master.
. For the serial tally setting, refer to "Setting of Serial Tally" in the user's guide.
. For setting the UTIL LAN IP address of system interface units, refer to "1-17-3. Network Settings for Connected
Devices."

1-15-6. Connection Example of Network AUX Remote

Switcher Control Station
PWS-100SC1/PWS-110SC1
t
. The following shows a connection example of the NS-BUS remote control panel to be used as an AUX remote controller
without using the system controller (PWS-110NM1/PWS-110RS1).
. This connection cannot be used together with the NS-BUS connection (shown in "1-15-3. Example of Connection to
NS-BUS").
. Only two models (MKS-R3210 and MKS-R1620) of NS-BUS remote control panel can be used in this connection.
. Up to 16 NS-BUS remote control panels per switcher control panel are connectable in this connection.
(Example: Up to 64 NS-BUS remote control panels are connectable in a system including four switcher control panels.)
ICP-X7000
LAN1
System Interface Unit
MKS-X2700
or MKS-X7700
MVS
LAN2
32 Button Remote Control Panel
MKS-R3210
LAN1
16 Button LCD Remote Control Panel
MKS-R1620
LAN1
Controller
UTIL
(Serial Tally over IP)
1-61 (E)