Standard Torques For Triple Lock Flange Joints - Kohler KD83V16 Service And Repair Manual

Service and Repair Manual
Fig. 246: Cutting ring lubrication
Information
To assemble pipes with cutting rings, proceed like following:
u Assemble pipe tension free. Mount support clamp after pipe assembling.
u Lubricate the surfaces of the connection, with engine oil.
Fig. 247: Cutting ring tightening
Information
u Screw in the nut of the cutting ring nut by hand.
u Hold the wrench as close as possible near to the nut.
u Tighten with a wrench until reaching the resisting point.
u Tighten by 90° maximal. While screwing nut A, preclude connector B to rotate.
page 211)
u If foreseen, proceed with the mounting of support clamps.

5.3.12 Standard torques for triple lock flange joints

Fig. 248: Triple lock flange joints
KD83V16 33525088901_1_1 EN_US
2019-02
.
© 2019 by Kohler Co. All rights reserved.
Standard tightening torques
(see: fig. 246, page 211)
(see: fig. 247,
Appendix
.
211