AMX NXA-ENET24 Instruction Manual page 97

CLI – This example creates a standard IP ACL named bill.
Console(config)#access-list ip standard bill264
Console(config-std-acl)#
Configuring a Standard IP ACL
Command Attributes
Web – Specify the action (i.e., Permit or Deny). Select the address type (Any, Host, or IP). If you
select "Host," enter a specific address. If you select "IP," enter a subnet address and the mask for an
address range. Then click Add.
FIG. 41 Configuring Standard IP ACLs
CLI – This example configures one permit rule for the specific address 10.1.1.21 and another rule
for the address range 168.92.16.x – 168.92.31.x using a bitmask.
Console(config-std-acl)#permit host 10.1.1.21265
Console(config-std-acl)#permit 168.92.16.0 255.255.240.0
Console(config-std-acl)#
Configuring an Extended IP ACL
Command Attributes
NXA-ENET Software Management Guide
Action – An ACL can contain permit rules, deny rules, or a combination of both.
(Default: Permit rules)
Address Type - Specifies the filter type - Any, Host, or IP. (Default: Any)
IP Address – Specifies the source IP address. Use "Any" to include all possible
addresses, "Host" to specify a specific host address in the Address field, or "IP" to
specify a range of addresses with the Address and SubMask fields. (Options: Any, Host,
IP; Default: Any)
Subnet Mask – A subnet mask containing four integers from 0 to 255, each separated by
a period. The mask uses 1 bits to indicate "match" and 0 bits to indicate "ignore." The
mask is bitwise ANDed with the specified source IP address, and compared with the
address for each IP packet entering the port(s) to which this ACL has been assigned.
Action – An ACL can contain permit rules, deny rules or a combination of both.
(Default: Permit rules)
Configuring the Switch
81