AMX NXA-ENET24 Instruction Manual page 60

Configuring the Switch
CLI – Type "show log ram" to display log messages in the RAM buffer.
Console#sh log ram
[2] 00:00:31 2001-01-01
"Unit 1, Port 13 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
[1] 00:00:31 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
[0] 00:00:31 2001-01-01
"System coldStart notification."
level: 6, module: 6, function: 1, and event no.: 1
Console#
System Logs Configuration
The System Logs page allows you to configure and limit system messages that are logged to flash
or RAM memory. The default is for levels 0 to 3 to be logged to flash and levels 0 to 7 to be logged
to RAM.
The level of messages logged to flash must be equal to or less than the level of
messages logged to RAM.
Command Attributes
Web – Click System, Log, System Logs. Specify the System Log Status, modify the level of
messages to be logged to RAM and flash memory, and then click Apply.
FIG. 16 Enabling System Logging
44
System Log Status – Enables/disables the logging of debug or error messages to the
logging process. (Default: Enabled)
Flash Level – Limits log messages saved to the switch's permanent flash memory for all
levels up to the specified level. For example, if level 3 is specified, all messages from
level 0 to level 3 will be logged to flash. (Default: 3)
RAM Level – Limits log messages saved to the switch's temporary RAM memory for all
levels up to the specified level. For example, if level 7 is specified, all messages from
level 0 to level 7 will be logged to RAM. (Default: 6)
217
NXA-ENET Software Management Guide