AMX NXA-ENET24 Instruction Manual page 48

Configuring the Switch
Manual Configuration
Web – Click System, IP. Specify the management interface, IP address and default gateway, then
click Apply.
FIG. 6 VLAN IP Configuration
CLI – Specify the management interface, IP address and default gateway.
Console#config
Console(config)#interface vlan 1300
Console(config-if)#ip address 10.2.13.30 255.255.255.0375
Console(config-if)#exit
Console(config)#ip default-gateway 10.2.13.254376
Console(config)#
32
Management VLAN – This is the only VLAN through which you can gain management
access to the switch. By default, all ports on the switch are members of VLAN 1, so a
management station can be connected to any port on the switch. However, if other
VLANs are configured and you change the Management VLAN, you may lose
management access to the switch. In this case, you should reconnect the management
station to a port that is a member of the Management VLAN.
IP Address Mode – Specifies whether IP functionality is enabled via manual
configuration (Static), Dynamic Host Configuration Protocol (DHCP), or Boot Protocol
(BOOTP). If DHCP/BOOTP is enabled, IP will not function until a reply has been
received from the server. Requests will be broadcast periodically by the switch for an IP
address. (DHCP/BOOTP values can include the IP address, subnet mask, and default
gateway.)
IP Address – Address of the VLAN interface that is allowed management access. Valid
IP addresses consist of four numbers, 0 to 255, separated by periods.
Subnet Mask – This mask identifies the host address bits used for routing to specific
subnets.
Gateway IP Address – IP address of the gateway router between this device and
management stations that exist on other network segments.
MAC Address – The MAC address of this switch.
Restart DHCP – Releases the current IP address and requests a new IP address from the
DHCP server.
NXA-ENET Software Management Guide