AMX NXA-ENET24 Instruction Manual page 183

Command Attributes
* Do not include the initial dot that separates the host name from the domain name.
Web – Select DNS, General Configuration. Set the default domain name or list of domain names,
specify one or more name servers to use for address resolution, enable domain lookup status, and
click Apply.
FIG. 104 Configuring DNS
NXA-ENET Software Management Guide
When an incomplete host name is received by the DNS server on this switch and a
domain name list has been specified, the switch will work through the domain list,
appending each domain name in the list to the host name, and checking with the specified
name servers for a match.
When more than one name server is specified, the servers are queried in the specified
sequence until a response is received, or the end of the list is reached with no response.
Note that if all name servers are deleted, DNS will automatically be disabled.
Domain Lookup Status – Enables DNS host name-to-address translation.
Default Domain Name* – Defines the default domain name appended to incomplete
host names. (Range: 1-64 alphanumeric characters)
Domain Name List* – Defines define a list of domain names that can be appended to
incomplete host names. (Range: 1-64 alphanumeric characters. 1-5 names)
Name Server List – Specifies the address of one or more domain name servers to use for
name-to-address resolution. (Range: 1-6 IP addresses)
Configuring the Switch
167