AMX NXA-ENET24 Instruction Manual page 326

Command Line Interface
Example
This example shows the configuration setting for port 25.
Console#show interfaces switchport ethernet 1/22
Information of Eth 1/22
Broadcast threshold: Enabled, 500 packets/second
Lacp status: Disabled
Ingress rate limit: disable,100M bits per second
Egress rate limit: disable,100M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan:
Forbidden Vlan:
Private-vlan mode: NONE
Private-vlan host-association: NONE
Private-vlan mapping: NONE
Console#
Show Interfaces Switchport Output - Description
Field
Broadcast threshold
Lacp status
VLAN membership mode
Ingress rule
Acceptable frame type
Native VLAN
Priority for untagged traffic Indicates the default priority for untagged frames (See page -355.)
Gvrp status
Allowed Vlan
Forbidden Vlan
310
1(u),
Description
Shows if broadcast storm suppression is enabled or disabled; if enabled it also shows the threshold level
(See page -305.)
Shows if Link Aggregation Control Protocol has been enabled or disabled (See page -315.)
Indicates membership mode as Trunk or Hybrid (See page -341.)
Shows if ingress filtering is enabled or disabled (See page -342.)
Shows if acceptable VLAN frames include all types or tagged frames only (See page -341.)
Indicates the default Port VLAN ID (See page -343.)
Shows if GARP VLAN Registration Protocol is enabled or disabled (See page -352.)
Shows the VLANs this interface has joined, where "(u)" indicates untagged and "(t)" indicates tagged (See
page -343.)
Shows the VLANs this interface can not dynamically join via GVRP (See page -344.)
NXA-ENET Software Management Guide