AMX NXA-ENET24 Instruction Manual page 250

Command Line Interface
Command Usage
Example
The following example shows how to upload the configuration settings to a file on the TFTP server:
Console#copy file tftp
Choose file type:
1. config:
Source file name: startup
TFTP server ip address: 10.1.0.99
Destination file name: startup.01
TFTP completed.
Success.
Console#
The following example shows how to copy the running configuration to a startup file.
Console#copy running-config file
destination file name : startup
Write to FLASH Programming.
\Write to FLASH finish.
Success.
Console#
234
The system prompts for data required to complete the copy command.
The destination file name should not contain slashes (\ or /), the leading letter of the file
name should not be a period (.), and the maximum length for file names on the TFTP
server is 127 characters or 31 characters for files on the switch. (Valid characters: A-Z, a-
z, 0-9, ".", "-", "_")
Due to the size limit of the flash memory, the switch supports only two operation code
files.
The maximum number of user-defined configuration files depends on available memory.
You can use "Factory_Default_Config.cfg" as the source to copy from the factory default
configuration file, but you cannot use it as the destination.
To replace the startup configuration, you must use startup-config as the destination.
The Boot ROM and Loader cannot be uploaded or downloaded from the TFTP server.
You must follow the instructions in the release notes for new firmware, or contact your
distributor for help.
For information on specifying an https-certificate, see Replacing the Default Secure-site
Certificate section on page 65. For information on configuring the switch to use HTTPS/
SSL for a secure connection, see ip http secure-server section on page 201.
When updating the PoE controller, first copy the PD controller file from a TFTP server to
the switch's file system (copy file tftp, and select "PD_Controller"), and then copy this
file to the controller (copy file controller, and select PoE).
When specifying the file type "PD_Controller" or "PoE" for copy operations, file types
other than PoE controller may be downloaded, but will not adversely affect the system.
2. opcode 3. PD_Controller: <1-3>: 2
NXA-ENET Software Management Guide