AMX NXA-ENET24 Instruction Manual page 107

Command Attributes
Web – Click Security, IP Filter. Enter the addresses that are allowed management access to an
interface, and click Add IP Filtering Entry.
FIG. 48 Entering IP Addresses to be Filtered
CLI – This example restricts management access for Telnet and SNMP clients.
Console(config)#management telnet-client 192.168.1.19198
Console(config)#management telnet-client 192.168.1.25
192.168.1.30
Console(config)#management snmp-client 10.1.2.3
255.255.255.255198
Console(config)#end
Console#sh management telnet-client199
Management IP Filter
TELNET-Client:
Start IP address
-----------------------------------------------
1. 192.168.1.19
2. 192.168.1.25
Console#sh management snmp-client199
Management IP Filter
SNMP-Client:
Start IP address
-----------------------------------------------
1. 10.1.2.3
Console#
NXA-ENET Software Management Guide
You can delete an address range just by specifying the start address, or by specifying both
the start address and end address.
Web IP Filter – Configures IP address(es) for the web group.
SNMP IP Filter – Configures IP address(es) for the SNMP group.
Telnet IP Filter – Configures IP address(es) for the Telnet group.
IP Filter List – IP addresses that are allowed management access to this interface.
Start IP Address – A single IP address, or the starting address of a range.
End IP Address – The end address of a range.
End IP address
192.168.1.19
192.168.1.30
End IP address
255.255.255.255
Configuring the Switch
91