Lacp Admin-Key (Ethernet Interface); Lacp Admin-Key (Port Channel) - AMX NXA-ENET24 Instruction Manual

Command Line Interface

lacp admin-key (Ethernet Interface)

This command configures a port's LACP administration key. Use the no form to restore the default
setting.
Syntax
Default Setting
Command Mode
Command Usage
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor admin-key 120
Console(config-if)#

lacp admin-key (Port Channel)

This command configures a port channel's LACP administration key string. Use the no form to
restore the default setting.
Syntax
318
lacp {actor | partner} admin-key key
[no] lacp {actor | partner} admin-key
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
key - The port admin key must be set to the same value for ports that belong to the same
link aggregation group (LAG). (Range: 0-65535)
0
Interface Configuration (Ethernet)
Ports are only allowed to join the same LAG if (1) the LACP system priority matches, (2)
the LACP port admin key matches, and (3) the LACP port channel admin key matches (if
configured).
If the port channel admin key (lacp admin key - Port Channel) is not set when a channel
group is formed (i.e., it has the null value of 0), this key is set to the same value as the
port admin key (lacp admin key - Ethernet Interface) used by the interfaces that joined
the group.
Once the remote side of a link has been established, LACP operational settings are
already in use on that side. Configuring LACP settings for the partner only applies to its
administrative state, not its operational state, and will only take effect the next time an
aggregate link is established with the partner.
lacp admin-key key
[no] lacp admin-key
key - The port channel admin key is used to identify a specific link aggregation group
(LAG) during local LACP setup on this switch. (Range: 0-65535)
NXA-ENET Software Management Guide