Switching the door unlock function
■
It is possible to set which doors the entry
function unlocks using the wireless remote
control.
1
Turn the engine switch off.
2
When the indicator light on the key sur-
face is not on, press and hold
or
seconds while pressing and holding
.
The setting changes each time an operation
is performed, as shown below. (When
changing the setting continuously, release
the buttons, wait for at least 5 seconds, and
repeat step 2.)
Multi-information
display/Beep
Pushing the depres-
sion on the front edge
of the driver's door
handle unlocks only
the driver's door.
Exterior: Beeps 3
times
Pushing the depres-
sion on the front edge
Interior: Pings
of the passenger's
once
door handle unlocks
both side doors.
Pushing the depres-
sion on the front edge
Exterior: Beeps
of either door handle
twice
unlocks both side
doors.
Interior: Pings
once
To prevent unintended triggering of the
alarm, unlock the doors using the wireless
remote control and open and close a door
once after the settings have been changed.
(If a door is not opened within 60 seconds
after
is pressed, the doors will be
locked again and the alarm will automati-
cally be set.)
3-2. Opening, closing and locking the doors and trunk
,
for approximately 5
Unlocking function
In a case that the alarm is triggered, imme-
diately stop the alarm. (P.65)
■
Impact detection door lock release sys-
tem
In the event that the vehicle is subject to a
strong impact, both side doors are
unlocked. Depending on the force of the
impact or the type of accident, however, the
system may not operate.
■
Operation signals
A buzzer sounds and the emergency flash-
ers flash to indicate that the doors have
been locked/unlocked. (Locked: once;
Unlocked: twice)
A buzzer sounds to indicate that the win-
dows are operating.
Depending on the opening/closing state of
the soft top roof, the buzzer may be
delayed.
■
Security feature
If a door is not opened within approximately
60 seconds after the vehicle is unlocked,
the security feature automatically locks the
vehicle again.
Open door warning buzzer
■
If an attempt to lock the doors is made when
a door is not fully closed, a buzzer sounds
continuously for 5 seconds. Fully close the
door to stop the buzzer, and lock the vehi-
cle once more.
Setting the alarm
■
Locking the doors will set the alarm system.
(P.65)
Conditions affecting the operation of
■
the smart access system with push-but-
ton start or wireless remote control
P.105
■
If the smart access system with push-
button start or the wireless remote con-
trol does not operate properly
Use the mechanical key to lock and unlock
the doors. (P.330)
Replace the key battery with a new one if it
is depleted. (P.297)
■
If the battery is discharged
The doors cannot be locked and unlocked
97
3