Table of Contents
Advertisement
remove the cover in the center of
the rear seat.
3
Insert the mechanical key into the
cylinder and turn it clockwise to
open.
WARNING
■
After unlocking the trunk
Make sure to put back the cover to the
center of the rear seat. Failure to do so
may cause an accident.
NOTICE
When installing the cover in the cen-
■
ter of the rear seat
Make sure that the seat belts are not
caught in the cover. Failure to do so may
cause damage to the cover installation
clip and make it impossible to install the
cover.
7-2. Steps to take in an emergency
Opening the glove box
The glove box can be opened by per-
forming the following operations after
unlocking the doors.
If the glove box is locked, unlock it with the
mechanical key. (P.246)
1
Remove the cover using a flathead
screwdriver.
To prevent damage to the cover, cover the
tip of the screwdriver with a rag.
2
Push the flathead screwdriver into
the part shown in the illustration to
open the glove box.
After opening the glove box
■
The glove box can be opened normally by
closing the glove box after restarting the
engine.
Restarting the engine
If you have a set of jumper (or booster)
cables and a second vehicle with a bat-
333
7
Advertisement
Table of Contents
