Basic principle
All devices at the TCS:BUS have got an unique serial number.
When programming a bell button, the serial number is allocated to an indoor station and
stored in the EEPROM of the front-door station. Per bell button, 1 or 2 indoor stations
(serial numbers) can be allocated and called.
When a bell button is not allocated to a serial number (condition ex works/allocation de-
leted), this button can be used to switch lights.
Programming a bell button
Make sure that the indoor station is connected to the TCS:BUS and the mains voltage is
switched ON (the LED at the power supply / control unit is ON).
Before an already programmed bell button can be programmed anew, the previ-
!
ous programming must be deleted.
Legend
press button shortly
press button until
release button
LED blinks
LED blinks fast
LED is ON
ring tone
Progsperr tone
period of time (e.g. 6 s)
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94 - 9 88 11 88
Fax: +49 (0) 41 94 - 9 88 129 E-Mail:
10
Bell button programming
busy tone
negative acknowledgement tone
(bell button already programmed)
SNapp tone
negative acknowlegdement tone
(NoProg tone)
delete-melody
Prog2 tone (start programming of
the 2nd serial number)
repeat
further
◄6s►
hotline@tcsag.de
3/2013
Subject to technical changes.
PI_PAK_uk 1A