The screw terminal with 5 poles to connect the front-door station with the TCS:BUS is plugable. Connect the TCS:BUS to a, b and P and if existing, connect a relay for controlling a door opener (FAA1100-0600) to the terminals R and P.
Check the a, b and P wire against each other for short-circuits. Switch on the mains voltage. TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes. FAX: +49 (0) 41 94/ 9 88 129 Mail: info@tcsag.de...
Programming a bell button Make sure that the indoor station is connected to the TCS:BUS and the mains voltage is switched ON (the LED at the power supply / control unit is ON).
Page 10
1) If a Progsperr tone sounds instead, a programming lock is set in the front-door station. The programming lock can only be removed with the Service Device TCSK-01. TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes.
1) If a Progsperr tone sounds instead, a programming lock is set in the front-door station. The programming lock can only be removed with the Service Device TCSK-01 or the configuration software configoTM. TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94/ 9 88 11 88 Subject to technical changes.