Programming State Of A Bell Button; Testing; Deleting The Programming - TCS AVU14 0 Series Product Information

The front-door stations are supplied un-programmed.
The programming state can be checked as follows:

Testing

press briefly
Before a pre-programmed bell button can be re-programmed, the programming must be
deleted.

Deleting the programming

1
Press briefly
2
Press
until
3
Press briefly
1) If Progsperr ton sounds the programming block is active. It can be removed by the service device TCSK-01 only.
TCS TürControlSysteme AG • Geschwister-Scholl-Str. 7 • 39307 Genthin
Phone.: +49 39 33 / 87 99 10 • Fax: +49 39 33 / 87 99 11 • www.tcs-germany.com
13

Programming state of a bell button

Noprog tone
ring tone
LED flashes
deletion tone release
1)
sounds ,
LED flashes
no more
bell button
un-programmed
bell button
programmed
programming
mode
of system
switched on
bell button
deleted
programming
mode
of system
switched off
Subject to change without notice.
PI_GB_AVU1_Art0016078_2v0.doc mi
05/2006