Programming A Second Indoor Station At A Bell Button (Parallel Call) - TCS PAK Product Information

Programming a second indoor station at a bell button (parallel call)

The parallel call is calling 2 indoor stations from the bell button of the front-door station.
The floor push button is only calling the permanently wired indoor station.
If bell button and floor push button are to have the same functionality, the function parallel
allocation must be used. Thus several indoor stations are reacting on the same bell button
as well as on the same floor push button. The parallel allocation has to be adjusted with
the Service Device TCSK-01 or the configuration software configo™.
Note: Repeated programming of an already programmed bell button always changes only the second seri-
al number. If you want to change the serial number programmed first, you have to delete both serial num-
bers and reprogram the device again.
1 Initiate
Power supply and control unit
press shortly
2a Programming via voice connection
oder
establish voice connec-
tion to the front-
door station
2b Alternative: Programming via floor push button
+
press floor push button
for 2 times in quick
succession, each time
a ring tone sounds
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94 - 9 88 11 88
Fax: +49 (0) 41 94 - 9 88 129  E-Mail:
LED blinks
◄6s►
press button until a Prog2
tone and a NoProg tone and
...
◄6s►
press button until a Prog2
tone and a NoProg tone and
...
Repeat the steps, until all bell buttons are programmed.
hotline@tcsag.de
12
Programming mode of the system is ON
◄6s►
... a ring tone at the front-
door and indoor station
sounds
(if the indoor station is not accessible)
◄6s►
... a ring tone at the front-
door station and indoor
station sounds
release
1)
release
1))
Subject to technical changes.
PI_PAK_uk 1A
3/2013