Win:clip Tm System; Installation - TCS PAK Product Information

The device is equipped with the win:clip system, thus opening and closing the station can
be realised without screws.
Open the housing
1. Push the enclosed win:clip key into the small open-
ing within the loudspeaker cover. Press the key into
the opening until stop and keep it in this position.
2. Push the name plate glass slightly upwards until it
jumps out.
3. Remove out the glass.
4. Remove the win:clip
Close the housing
5. Push the enclosed win:clip key into the small open-
ing within the loudspeaker cover. Press the key into
the opening until stop and keep it in this position.
6. Push the name plate glass under the loudspeaker
cover.
7. Press the name plate glass onto the device. Push it
slightly downwards until it snaps-in.
8. Remove the win:clip
For a fully operational function of the microphone a distance of 5cm below the device
!
must be observed!
1. Open the front-door station (see win:clip
2. Break through the foam cover at the backside of the device carefully and insert the lines
through the cable gland.
3. Install the front-door station at both attachment holes with suitable screws to the wall.
Take care that the lines are not clamped under the spacer on the backside of the
!
device.
TCS TürControlSysteme AG, TCS Hotline Germany: +49 (0) 41 94 - 9 88 11 88
Fax: +49 (0) 41 94 - 9 88 129  E-Mail:
win:clip
TM
key.
TM
key.

Installation

hotline@tcsag.de
6
TM
system
TM
system).
3/2013
Subject to technical changes.
PI_PAK_uk 1A