Repair; Error Detection And Indication; Exchange An Indoor Station - Programme Bell Buttons - TCS ISW3130 Product Information

20 Ohm:
max. 160 m distance AS/IS-VS by 0.6 mm diameter
max. 300 m distance AS/IS-VS by 0.8 mm diameter

Error detection and indication

Faults are signalled optically and acoustically: constant fault tone and constant flashing of
the operation display. When pressing any button, a fault tone sounds again. The optical
fault indication stays active until the fault is corrected.
fault causes
a- and P-wire are inter-
changed or short-circuited
a-wire: not connected or
not supplied
button stucks
(press longer than 15 sec)
Exchange an indoor station – programme bell buttons
Basics
 All devices at theTCS:BUS have got an unique serial number.
 Programming a bell button means that the serial number of an indoor station is allocat-
ed to the bell button of a front-door station and is stored within the EEPROM of the
front-door station.
 Ensure that new the indoor stations is connected to the TCS:BUS and the mains volt-
age is switched on (the operation LED at the power supply and control unit is ON) and
further, that the access to the flat is granted during the programming.
 This instruction describes the case that a serial number is allocated to the bell button
without setting a programming lock. To neutralise a programming lock you need a Ser-
vice Device TCSK-01or the configuration software configo™.
TCS TürControlSysteme AG
E-Mail: hotline@tcsag.de • www.tcsag.de
14

Repair

display
fault fault tone
mode
both
LEDs
flash
AS front-door station
VS power supply and control unit
IS indoor station
FE extended functions
elimination
change a- and P-wire or eliminate short-circuit,
device is in stand-by mode again
connect the a-wire or check power supply,
device is in stand-by mode again
remove button at the device or loosen floor push but-
ton, device is in stand-by mode again
Subject to technical changes.
PI_ISW3130-uk
07/2015
a, b hier
kurzschließen
2 A