S
ETUP
Using the Device
To connect to a power
source
Using the Device
Using the Multi-Card
Reader
To conduct a card
transaction
WARNING
30
UX300 I
NSTALLATION
Connect the power cable to the power port on the UX300 and the other end to
your power source.
Figure 19
Power Connection Options for the UX300 Series
Card transaction procedures vary depending on the application. Verify the proper
procedure with your application provider before performing a card transaction.
The UX300 supports magnetic stripe cards as well as smart cards. Use the
following steps in conducting UX300 card transactions.
Position the card with the magnetic stripe facing downward and to the right of the
card, or with the chip on top of the card and towards the card slot (see
Figure 20
Using the Multi-Card Reader
1
If using a magnetic stripe card, insert the card fully into the slot, then remove
the card in a smooth continuous motion.
You will lose transaction data files not yet stored in memory if there is a disruption
in power supply during a transaction.
G
UIDE
A
B
Figure
20).