Normal Operation Mode; Installing Sim Card And Antenna - VeriFone UX300 Installation Manual

Normal Operation
Mode
Installing SIM
Card and
Antenna
WARNING
To install or replace
the card
NOTE
Do not use the UX300 unless it is in normal operation mode. By default, the
position of the toggle switch located on the side of the SAM compartment is set to
High. There are cases where the switch is moved especially when the device is
sent for servicing and upgrade. When this happens, use a tweezer or a similar tool
to toggle the switch back to High. To make sure that the switch is in High position,
the switch must be aligned with the number 1 located beside the SAM slot as
shown in the illustration below.
Figure 9 Toggle Switch Set to High Position
The UX300-GPRS unit supports the installation of a GSM SIM (Subscriber Identity
Module) for fast, always on connectivity. Use the following procedure to install a
SIM card and attach the GPRS antenna.
Changing or inserting new SIM cards on a powered unit can render the SIM card
unusable. Disconnect all power sources before performing the SIM card
installation or replacement procedure.
1
Disconnect the device from all power sources.
2
Disconnect the device from any external devices.
3
Lift up and twist the rubberized SIM Card cover to the side.
4
Open the SIM cardholder by sliding the locking tab towards the back of the
unit, to the
UNLOCK
There is only one GSM SIM slot. Before inserting the SIM card, position it as
shown in the illustration, with the card's gold contacts facing the compartment.
The cardholder connector base has a set of contacts and a notch to ensure the
SIM/RUIM card is positioned correctly. The SIM card has a notch on one corner
to ensure that it fits into the connector base in only one way.
OPEN
LOCK
OPEN
LOCK
1
position.
S

Installing SIM Card and Antenna

UX300 I G
NSTALLATION UIDE
ETUP
21