Removal Protection; System Mode Activation; Installing Or Replacing Sam Cards - VeriFone UX300 Installation Manual

Removal Protection

CAUTION
System Mode
Activation
Installing or
Replacing SAM
Cards
CAUTION
To install or replace
SAM cards
The front Anti-Removal Switches (ARS) detect any removal attempt from the
device cabinet and disables the PIN processing functionality. Re-installation
requires an authorized process. Please contact your Verifone representative for
details.
Make sure the installation method does not invalidate the Anti-Removal Switch
(ARS) function. Do not, for instance, install the UX300 in a sub-chassis that can
be removed from the main cabinet.
The rear service switch gives administrators System Mode access for the UX300.
Use only if you have the proper authorization and equipment to open system
mode. Please contact your Verifone representative for details.
You may need to install a security access module (SAM) card or replace the old
card. You can find two SAM slots on the UX300, located under a removable
protective cover (see Figure
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. Verifone recommends using
a grounded anti-static wrist strap.
1
Disconnect the device from all power sources.
2
Disconnect the device from any external devices.
3
Slide the SAM cardholder cover away from the unit, off the top panel.
Figure 6 Removing the SAM Cardholder Casing
4
Open the SAM cardholder by sliding the locking tab towards the back of the
unit, to the position.
OPEN
6).

Installing or Replacing SAM Cards

UX300 I G
NSTALLATION UIDE
S
ETUP
19