Table of Contents
Advertisement
Connecting
Power Supply
CAUTION
NOTE
Power Connections
NOTE
5
Replace the nuts and tighten to the recommended torque of 7.0 kgfcm (6.1
lbf.in).
Not all UX300 configurations and device contexts require the use of a power
supply. Verifone ships power supplies with the UX300 as required.
If you have questions about which power supply to use, contact your Verifone
representative. For more information, see
Using an incorrectly rated power supply can damage the unit or cause it to
malfunction.
Verifone recommends the PWR159-001-01-A or CPS12490-4A-R power pack.
See
Specifications
for power supply information.
Attach and route all cables between the UX300 and all peripheral units before
connecting to the power source.
To protect against possible damage caused by lightning strikes and electrical
surges, Verifone recommends installing a power surge protector.
The UX300 connects to external power in the following ways:
•
With a 4-pin cable (VPN CBL159-308-01-A) from the power port on the
persistent board (see A in
•
With a 6-pin cable (VPN CBL159-309-01-A) from the power port on the model-
dependent board (see B in
Your power connection depends on your specific card reader configuration.
Verifone ships variants of the UX300 for different markets. Your unit may have a
different configuration and may look different from the illustrations in this guide.
However, the basic process described in this guide remain the same, regardless
of the configuration.
For more information regarding your card reader configuration, contact your local
Verifone service provider. For cable ordering information, see
Documentation).
Accessories and
Figure
19), or
Figure
19).
S
Connecting Power Supply
Documentation.
Accessories and
UX300 I
G
NSTALLATION
UIDE
ETUP
29
Hide quick links:
Advertisement
Table of Contents
