4-10. Front Frame Assembly
Preparation
1. Remove the front panel assembly. (Refer to "4-2-1. Front Panel Assembly".)
2. Remove the top cover assembly. (Refer to "4-3. Loader Assembly".)
3. Remove the KY-800 board. (Refer to "4-11-4. KY-800 Board".)
Procedure
1. Remove the two screws (M2 x 2.7) to remove the front flame assembly.
Front frame assembly
Special head screw
(M2 x 2.7)
Note
When attaching the front frame assembly, observe the following instructions.
•
Fit the two bosses with the two holes.
•
Install it with the loader assembly roller set on the plate.
2. Install the removed parts by reversing the steps of removal.
Boss
Hole
Special head screw (M2 x 2.7)
Roller
Plate
Boss
Roller
Hole
Plate
87