Table of Contents
Advertisement
4-11-8. SE-1005A Board
Preparation
1. Remove the front panel assembly. (Refer to "4-2-1. Front Panel Assembly".)
2. Remove the rear panel. (Refer to "4-2-2. Rear Panel".)
3. Remove the loader assembly. (Refer to "4-3. Loader Assembly".)
Procedure
1. Disconnect the three flexible cables from the connectors (CN1, CN2, CN36) on the SE-1005A board.
2. Remove the five screws (P1.7 x 2.5), and then remove the SE-1005A board.
Locking tab
Connector
(Type E)
SE-1005A board
Note
•
When installing the SE-1005A board, fit the nine bosses with the nine holes.
•
Install the FPC SE1005-LDR36 with the stiffening plate facing up.
3. Install the removed parts by reversing the steps of removal.
Note
Before installing a new SE-1005A board, bend it to prevent it from floating.
CN2
P1.7 x 2.5
CN1
Holes
Bosses
Holes
CN36
Holes
Connector
(Type C)
Bosses
FPC (sled motor)
FPC (spindle motor)
FPC SE1005-LDR36
Stiffening plate
facing up
Locking tab
Connector
(Type D)
102
Advertisement
Table of Contents
