Set Ip Routing - 3Com OfficeConnect Remote 812 Cli User's Manual

Parameter
<network_name>
broadcast_algorithm
reassembly_
maximum_size
rip_authentication
rip_policies_update
routing_protocol

set ip routing

autonomous_system_number [number]


table_maximum_size [number]


metric_maximum_entries [number]


rip_flags [METRICS, SEND_REQUEST]


router_id [router_id]


Sets parameters for IP routing to the specified IP router address, which is the
gateway to an Autonomous System.
Parameter
autonomous_system_number Autonomous system number.
table_maximum_size
metric_maximum_entries
Description
Designation of the IP network for which you want to set parameters.
Algorithm determines which address is used in broadcasts to represent
the entire network. Choices are:
1 - the IETF standard, nnn.nnn.nnn.255 (default)
0 - the BSD standard, nnn.nnn.nnn.000
Maximum size IP datagram that the system will try to reassemble, when
the datagram has been fragmented to fit in the network packet size.
The default is 3468.
Text string used for RIPv2 authentication.
Allows user to enable or disable RIP policies. See text on the preceding
page for description of keywords. A keyword with a NO_ in front is
used to disable the policy. The default is indicated by (D).
SEND_DEFAULT/NO_SEND_DEFAULT(D)
SEND_ROUTES(D)/NO_SEND_ROUTES
SEND_SUBNETS/NO_SEND_SUBNETS(D)
ACCEPT_DEFAULT/NO_ACCEPT_
DEFAULT(D)
SPLIT_HORIZON(D)/NO_SPLIT_HORIZON
POISON_REVERSE(D)/NO_POISON_
REVERSE
FLASH_UPDATE(D)/NO_FLASH_UPDATE
SEND_COMPAT(D)/NO_SEND_COMPAT
RIPV1_RECEIVE(D)/NO_RIPV1_RECEIVE
RIPV2_RECEIVE(D)/NO_RIPV2_RECEIVE
SILENT (default is disabled)
Sets routing protocol to be used on IP network. Choices are: no routing
protocol, RIP version 1, or RIP version 2.
Description
Maximum number of IP routes system can hold in its table.
Default: 1000
Most next hop entries the system table can maintain.
CLI Commands B-29