Add Dns Host <Host_Name> Address <Ip_Address; Add Dns Server <Domain_Name; Add Filter <Filter_Name - 3Com OfficeConnect Remote 812 Cli User's Manual

B-2 A B: CLI C
PPENDIX OMMAND
add dns host
<host_name> address
<ip_address>
add dns server
<domain_name>
add filter
<filter_name>
D
ESCRIPTION
You must use add user to create a network type user for this command, and set
user to specify the protocol and other parameters related to bridging.
Parameter Description
<network_name> Designation you wish to give to this bridge network.
enabled Default is to enable the bridge network.
Adds the named host to the Local Host Table. When the system needs to resolve
an address for an IP host name, the Local Host table is checked first, before a
request is sent to the remote DNS Name Server.
The add login_host command may also add to this table. See that command's
description for details.
Parameter Description
<host_name> Designation of the local host.
<ip_address> IP address of a named host in nnn.nnn.nnn.nnn format.
primary_address [ip_address]


secondary_address [ip_address]


vc_name [vc_name]


Adds the IP address of a remote DNS Server for the specified Domain Name to the
Domain Name Server Table. The first specified server is sent the IP host name to be
resolved, first without, and then with the default domain name (see set dns for
more information about the default domain name). If that server cannot resolve
the name, it is sent to the next specified server. If PPP is being used for a wide area
connection, the vc_name parameter to specify a remote connection from which
the primary and secondary addresses will be learned.
Parameter Description
<domain_name> Domain name. Use * for all domains.
Status The status concerning the DNS server.
primary_address The primary IP address of the DNS server.
secondary_address The secondary IP address of the DNS server.
vc_name The VC profile to use for obtaining the DNS addresses
Adds a filter file name to the filter table. The filter table is a managed list of filter
names used by SNMP. A filter file is a text file stored in the FLASH file system, that
you load using TFTP. Add filter also verifies the syntax of the filter file.
If syntax verification fails, you'll receive an error message, and the filter will still be
added to the table, but is not usable.