Ip Configuration (Network Service Rfc 1483) - 3Com OfficeConnect Remote 812 Cli User's Manual

Enter the local ip address for the WAN connection: (specified
only)
Do you want to use "name"'s remote router as the default
gateway ?
Do you want to run RIP ?
Enter the version of RIP to run: (if applicable)
The IP configuration for VC "name" is now complete.
IP Configuration Port Address Translation (PAT) allows a single WAN-side IP address to be 'shared'
(Network Service by multiple LAN-side devices.
RFC 1483)
If you choose to run PAT the WAN interface must be Numbered. (i.e., there must
be a local WAN-side IP address specified that must be on a different IP network
than the LAN-side IP address). For a discussion of Numbered and Unnumbered
interfaces, see "Configuring IP Routing" in the Online User's Guide.
Local and remote IP addresses can be configured in two different ways:
One active VC profile can have its remote router installed as the default router in
the OCR 812's IP route table.
You can use Routing Information Protocol (RIP) to exchange routing information
with other routers on the network.
The IP mask can be specified either as a class ("A", "B", or "C"), the number of
one bits in the mask, or as an address in the format 255.x.x.x.
Question
Is IP traffic going to be routed over VC "name" ?
Do you want to enable IP Port Address Translation (PAT) ?
Are the IP addresses (S)pecified or (L)earned ?
Enter the IP address of the router across the WAN:
Enter the IP mask for the router across the WAN:
Is the WAN interface (U)nnumbered or (N)umbered ?
Enter the local ip address for the WAN connection: (numbered
only)
Do you want to use "name"'s remote router as the default
gateway ?
Do you want to run RIP ?
Enter the version of RIP to run:
The IP configuration for VC "name" is now complete.
Specified: the IP address is always a specific address.


Learned: the IP address can be learned using DHCP.


CLI QuickVC Setup Script
[ ]
[no]
[no]
[v2]
Default Your System
[yes]
[yes]
[L]
[ ]
[C]
[N]
[ ]
[no]
[no]
[v2]
5-3