Cli Command Description; Cli Commands; Add Access <Ip Subnet Address; Add Auto_Filter Eth_Blk_Dst - 3Com OfficeConnect Remote 812 Cli User's Manual

B

CLI Commands

ADD
add access
<ip subnet address>
add auto_filter
eth_blk_dst
add auto_filter
vc_blk_netbios
add bridge network
<network_name>

CLI Command Description

Use the ADD command to define:
Networks you will connect to


Hosts you need to access


SNMP communities


Users who will dial out, dial in, access the network, or use the CLI


Note that some parameters have default values.
The access list defines which Remote IP Subnets are allowed access to the
Management services of the OCR812. Use this command to add an entry to the
list.
Parameter Description
ip subnet address IP address in the xx.xx.xx.xx/mask format.
Automatically adds and enables a blocking destination subnet address on the
Ethernet interface.
Address - IP address of the subnet to be blocked.


Mask - IP netmask of the subnet to be blocked.


Automatically adds and enables an input filter on the specified VC. The filter DP
ports 137 and 138, and TCP ports 139 and 143.
VC - Specified VC profile name.


{ enabled [yes] }


Defines a bridge network connection, so your LAN users can bridge to other LANs
across the WAN. bridging is supported over the WAN.
Note that routing takes precedence over bridging, so that bridging will not occur
unless you disable routing for the protocols you wish to bridge. The protocols to
bridge, and other important parameters, are specified in the user you use to
establish this connection.