19-4
C
19: T
HAPTER
UNNELING
list pptp tunnel <number>
sessions
list pptp tunnels
Show Commands
show pptp,
show pptp settings
C
OMMANDS
address - address of particular PPTP Network Server in the table.
PPTP LOCAL PNS LIST
Index
1
2
Displays information on all current PPTP tunnel sessions.
Tun(nel) ID - designation of the PPTP pipe
Ses(sion) ID - designation of the PPTP session
Status - status of the tunnel session. Values displayed are NO STATE,
ALLOCATED, WAITING, CALLING, OFFERING, ANSWERING, CONNECTED,
DISCONNECTING LOCAL, DISCONNECTING REMOTE, or LOST CONTROL
TUNNEL
User Name - Designation of user active on this tunnel session.
PPTP SESSIONS
TunID
SesID
1
1
Displays settings for all current PPTP tunnels.
Tun(nel) ID - designation of the PPTP tunnel
Status - state of the tunnel. Values displayed are NO STATE, ALLOCATED,
CONNECTING, STARTING SESSION, ESTABLISHED, STOPPING SESSION,
DISCONNECTING, LOST, or IDLE TIMEOUT
IP address - IP address of the remote tunnel endpoint to which it is connected.
Depending on the RAS executing the command, if looking at the PNS, this
value is the LAC address.
PPTP TUNNELS
TunID Status
1
ESTABLISHED
Displays settings for configured PPTP tunnels.
Maximum Number of Sessions - Maximum number of simultaneous active
sessions PPTP supports.
Maximum Number of Tunnels - Maximum number of simultaneous active
tunnels PPTP will support. Since sessions are multiplexed within a single tunnel,
this value displays the number of PPTP tunnels supported per tunnel.
Number of Control Channel Seek Descriptor - Number of tunnel
terminators PPTP can simultaneously connect to. The default is 8
Flow Control - Whether PPTP uses flow control on the data tunnel. The
default is enabled
Address
134.234.123.43
134.234.123.45
Status
UserName
CONNECTED
curly
IP address
149.112.214.102
.
.