Igmp Commands; Set Command - 3Com OfficeConnect 3C100XF Cli User's Manual

15-2 C 15: M
HAPTER ULTICASTING AND
set ip multicast proxy
interface <interface_name>

IGMP Commands

Set Command

set ip igmp [eth:1 |
slot:x/port:y]
IGMP C
OMMANDS
threshold <number>
window <number>
These parameters are described in the following table.
Parameters Description
<interface_name> The interface on which to monitor multicast traffic for the specified
group: eth:1, slot:x/port:y, or username
group The IP address of the multicast group to monitor.
time The interval, in seconds, to monitor multicast traffic. The range is 0 -
65535. The default is 60.
threshold The interval during which multicast traffic is not received after which
an SNMP trap is issued. The range is 0 - 65535. The default is 3.
window The number of periods (in time values) to monitor multicast traffic. The
range is 0-255. The default is 5.
Multicast addresses that are joined or learned on the specified interface are joined
on the proxy interface that is configured with this command. The value for
<interface_name> can be in the form Eth:1, slot:x/port:y or username.
See the set ip igmp [eth:1 | slot:x/port:y] command for more information.
Specifies IGMP settings to configure IP multicast groups. The OfficeConnect
Gateway performs IGMP forwarding. (Note: the present release does not support
IGMP routing protocols such as PIM and DVMRP.)
The command has the following parameters:
max_response_time <1-10 seconds>
multicast_forwarding [enabled | disabled]
multicast_proxy [enabled | disabled]
query_interval <5-65,535 seconds>
robustness <1-5>
routing [enabled | disabled]
version <1-2>
These parameters are described in the following table.
Parameters Description
<interface_name> The interface on which IGMP is enabled: eth:1 or slot:x/port:y
max_response_time The interval a host has to respond to the IGMP query. The default is 10.
The range is 1-10 seconds.
multicast_forwarding Multicast packets are forwarded when enabled. The default is
disabled.
multicast_proxy Multicast addresses that are joined or learned on the specified interface
are joined on the proxy interface that is configured with the set ip
multicast proxy interface command. The default is Disabled.