Table of Contents
Advertisement
Delete Command
delete traceroute row
<number>
List Commands
list traceroute
Removes a specified row from the main traceroute table when entered from an
SNMP station or via a command file. The CLI deletes the row immediately upon
completion of the traceroute. The range is 1-65535. See traceroute, list
traceroute, set traceroute maximum_rows and show traceroute commands
for more information.
Displays the current rows in the main traceroute table when entered from an
SNMP station or via a command file. Rows entered from the CLI are automatically
deleted upon traceroute completion but rows entered from an SNMP station will
persist for 30 minutes. See traceroute, delete traceroute, set traceroute
maximum_rows and show traceroute commands for more information.
Row - Rows currently active in Traceroute Table
Destination - host name or IP address of traceroute target
Hop Count - Number of hops traceroute has traveled to reach destination
State - Status of traceroute process associated with this row
When using SNMP or a command file only to perform a traceroute list, the
following states may be reported.
Traceroute-generated packets received by the OfficeConnect Gateway will not
increment the ICMP error counters Time Exceeded and Destination Unreachable.
See attributes below.
Active - specified IP address (host) is resolved
Not Active - before this row is activated
Waiting DNS - awaiting DNS resolution
DNS Failed - destination address could not be resolved due to timeout or
other reason
Bad address - resolved IP address is illegal
Hop Timeout - timeout occurred
Hops Exceeded - maximum number of hops exceeded
Dest Unreachable - a route to the host could not be found
Tracing - performing traceroute
Completed - traceroute completed successfully
Resource Failure - not enough resources to complete the command
Row
Destination
1
132.143.24.70
3
mayflower
4
moth
Hop Count
State
12
Active
30
HOPS EXCEEDED
30
HOPS EXCEEDED
CLI Commands
29-3
Advertisement
Table of Contents
