Configuring And Managing Users; Overview; Add Commands - 3Com OfficeConnect 3C100XF Cli User's Manual

4

Overview

Add Commands

add user <name>
C
ONFIGURING AND
This chapter identifies and describes the CLI commands you can use to configure
and manage the authorized users of the OfficeConnect Gateway.
You can configure all remote networking parameters associated with the profile of
the user who is accessing the OfficeConnect Gateway. A user profile specifies the
user's protocol, address parameters, and other unique settings.
The following table identifies the commands that can be used for configuring and
managing users of the OfficeConnect Gateway:
Command Command Name
Type
Add add user <name>
add address_pool user <user_name>
Delete delete user <name>
delete address_pool user <user_name>
Enable enable user <name>
Disable disable user <user_name>
Disconnect disconnect user <name>
List list users
Set set user <user_name>
set framed_route user <name>
set maximum_local_users <number>
Show show user <name>
The add user <name> command adds a user to the Local User Table. You may
specify a type for the user, as well as the login protocol, or use the defaults.
The following parameters are associated with this command:
enabled [yes | no]
login_service [rlogin | telnet]
password <password>
type [login, network, manage, manage_readonly]
M
ANAGING
U
SERS