Maintaining The Sprayer System; Checking Sprayer System; Cleaning; Cleaning The Engine And The Exhaust System Area - Toro 34230 Operator's Manual

Maintaining the Sprayer
System

Checking Sprayer System

Service Interval: Every 50 hours
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Check all hoses, nozzles, and fittings for
damage and leaks.
Note:
Replace all damaged or leaking sprayer
components.
3. Check the nozzle strainers and in-line strainers
for accumulation of dirt and chemical sludge.
Note:
Clean or replace strainers with an
accumulation of dirt and chemical sludge.

Cleaning

Cleaning the Engine and
the Exhaust System Area
Service Interval: After each use (may be required
57).
Excessive debris around engine-air intake
and exhaust system area can cause engine,
exhaust area, and hydraulic system to
overheat which can create a fire hazard.
Clean all debris from engine and exhaust
system area.
Cleaning the Debris from
the Machine
Service Interval: After each use
Removing the Engine
Shroud and Cleaning the
Cooling Fins
Service Interval: Every 80 hours
72
more often in dry or dirty conditions.)
CAUTION
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Clean all debris from screen next to the starter
grip of the engine, around engine shrouding, fuel
tank, and exhaust system area.
3. Wipe up any excessive grease or oil around the
engine and exhaust system area.
4. Clean muffler-heat shields of all debris, dirt, and
oil.
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Clean off any debris or chemical build-up on the
machine, especially the nozzles, sprayer-tank
opening, impeller, and the spray wand and its
holder.
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Remove cooling shroud from engine.
3. Clean cooling fins of the engine.
Note:
Also, clean dust, dirt, and oil from
external surfaces of engine which can cause
improper cooling.
57).
57).
57).