Servicing The Transaxle; Controls System Maintenance; Adjusting The Pattern Control Cable For The Spreader - Toro 34230 Operator's Manual

Servicing the Transaxle

Service Interval: Every 50 hours
Transaxle Oil Type: Toro® HYPR-OIL™ 500
hydraulic oil or Mobil® 1 15W-50
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Rotate counterclockwise the 2 quarter-turn
fasteners that secure the knee pad to the
chassis of the machine
Figure 97
1. Quick release screws
2. Knee pad
3. Lift the knee pad up and rearward slightly and
remove the pad from the machine
4. Clean area around fluid-expansion tank and
remove cap (Figure
5. Check the fluid level in the expansion tank.
Note:
The fluid-level cover the bottom port in
tank.
6. If the fluid level is too low, add the specified fluid
into the expansion tank.
7. Install the tank cap onto the expansion tank and
tighten the cap until it is snug
Note:
Do not overtighten the cap.
57).
(Figure 97).
3. Oil expansion tank
(Figure 97).
97).
(Figure 97).
Controls System
Maintenance
Adjusting the Pattern
Control Cable for the
Spreader
1. Prepare the machine for maintenance; refer to
Preparing the Machine (page
2. Empty the hopper; refer to
Spreader (page
3. Close the impeller gate by pushing the heavy
distribution granular-gate lever forward fully
(Figure 98).
g027155
1. Unlock—spread pattern
control handle (rotate
counterclockwise)
2. Push down—spread
pattern control handle
4. Rotate the spread-pattern-control handle
counterclockwise, push the handle down,
and rotate the spread-pattern-control handle
clockwise(3) refer to
5. Loosen the jam nut at the end of the
pattern-control cable
70
57).
Emptying the
30).
Figure 98
3. Lock—spread pattern
control handle (rotate
clockwise)
4. Push forward—heavy
distribution granular-gate
lever
Figure 98.
(Figure 99).
g305495