Sprayer Controls - Toro 34230 Operator's Manual

Spreader and Information Display
The spreader and information display is located below
the distribution impeller-gate levers at the bottom of
the control console (Figure
The spreader and information display shows the
following information:
•
The spreader controller firmware version
•
An hour meter for the spreader-impeller motor
•
The speed of the impeller motor as a percent of
motor-rotation speed
•
Fault codes
Drop-rate Cam and Linkage
The drop-rate cam and linkage are located at the front
of the machine and below the hopper on the spreader
(Figure 11).
1. Slot–maximum position
Use the drop-rate cam to set the maximum amount of
material to be dispensed through the impeller gate
and onto the impeller.
The slot in the cam, after setting 9 on the cam,
allows you to open the impeller gate to the maximum
position. You can use this setting for dry sand, ice
melt, or other materials that are difficult to spread.
Note:
Use cam setting 9 may when you are cleaning
out the hopper.
10).
Figure 11
2. Linkage

Sprayer Controls

1. Tank-agitation lever
2. Narrow-spray pattern lever 6. Sprayer-pump switch
3. Wide-spray pattern lever
4. Sprayer wand
Tank-Agitation Lever
The tank-agitation lever is located on the control
console (Figure
g027033
Setting the tank-agitation lever to the O
allows the sprayer pump to circulate the content in the
spray tank to keep the chemical solution mixed.
•
Pull the tank-agitation lever to circulate the content
in the spray tank.
•
Push the lever to stop circulating the content in
the spray tank.
Note:
Do not use agitation while spraying. Shut
off the tank agitation to ensure proper spray
distribution.
Note:
Run the engine speed above idle and run the
sprayer pump for the tank agitation to work effectively.
Narrow-Spray Pattern Lever
The narrow-spray pattern lever is located on the
control console
•
To turn the sprayer in a narrow-spray pattern
ON
(the center nozzle only), pull the narrow-spray
pattern lever toward you.
•
To turn
OFF
pattern lever away from you.
14
Figure 12
5. Sprayer and information
display
7. Spray-wand pressure
control
12).
(Figure 12).
the sprayer, push the narrow-spray
g304858
position
N