Electrical System Maintenance; Servicing The Battery - Toro 34230 Operator's Manual

Stand-on e-spreader/sprayer
Table of Contents

Advertisement

Figure 86
1. Drain bolt
5.
Install the drain bolt into the side port of the
carburetor.
6.
Open the fuel shutoff valve and check for leaks.
Note:
Repair all fuel leaks before operating the
engine.
g257991
2. Side port of the carburetor
bowl
Electrical System
Maintenance

Servicing the Battery

Service Interval: Monthly
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution of
4 parts water and 1 part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 V
DANGER
Charging or jump starting the battery may
produce explosive gases. Battery gases can
explode causing serious injury.
• Keep sparks, flames, or cigarettes away
from battery.
• Ventilate when charging or using battery in
an enclosed space.
• Ensure that the venting path of battery is
always open once the battery is filled with
acid.
• Do not lean over the batteries.
• Always shield eyes and face from battery.
DANGER
Battery electrolyte contains sulfuric acid,
which is poisonous and can cause severe
burns. Swallowing electrolyte can be fatal or
if it touches skin can cause severe burns.
• Wear eye protection to shield your eyes
and rubber gloves to protect your skin and
clothing when handling electrolyte.
• Do not swallow electrolyte.
• In the event of an accident, flush with water
and call a doctor immediately.
63

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents