Servicing The Fuses - Toro 34230 Operator's Manual

Note:
The positive battery cable is wired to the
starter or solenoid.
1. Positive (+) cable on the discharged battery
2. Positive (+) cable on booster battery
3. Negative (–) cable on the booster battery
4. Negative (–) cable on the engine block
5. Booster battery
6. Discharged battery
7. Engine block
4. Connect the other positive (+) cable clamp (red)
to the positive terminal of the booster battery.
5. Connect the negative (–) cable clamp (black) to
the negative terminal of the booster battery.
6. Connect the other negative (–) cable clamp
(black) to the engine block of the stalled machine
and away from the discharged battery.
Important:
Do not connect the negative (–)
cable clamp (black) to the negative battery
post of the discharged battery.
7. Stand away from the discharged battery of the
machine.
8. Start the machine and remove the cables in
the reverse order of connection, disconnect the
engine block connection first.

Servicing the Fuses

The electrical system is protected by fuses, and
requires no maintenance. If a fuse blows, check the
component or circuit for a malfunction or short.
1. Remove the negative battery cable from the
battery terminal; refer to steps
Removing the Battery (page
Note:
Ensure that the negative battery cable
does not touch the battery terminal.
2. Push the latch on the fuse/relay holder and
separate the cover from the holder
3. Pull the fuse from the socket of the fuse/relay
holder (Figure 91).
Figure 90
2 and 3
65).
(Figure
g012785
1. Cover
2. Fuses
4. Install a fuse (20 A) of the same type into the
socket of the fuse/relay holder
5. Install the cover onto the fuse/relay holder until
the cover latches securely
6. Install the negative battery cable to the battery
terminal, and install the battery cover; refer to
steps
of
91).
67
Figure 91
3. Negative battery cable
4. Fuse/relay holder
(Figure
5 and 6 of Installing the Battery (page
g306403
g304903
(Figure 91).
91).
66).